Jump to content
mark poulson

Lee Pots Help

Recommended Posts

I put the thermo coupling from the pid and place it so it touched the heating element. Don't know if that was best , but if I set it to 350 the element runs to that setting.

 

That's a really smart idea - takes some of the issues of the amount of plastic in the cup out of the equation.  I recently hooked up a PID to my presto - might see if touch off on the bottom instead of having it a few millimeters above the bottom in the plastic helps.

 

    J.

Link to comment
Share on other sites

This bait was poured from a Lee pot. I have been pouring baits for years using these pots and yes they are tricky to say the least. You can purchase pots with small holes in the spouts and purchase pots with the regular hole size too. You can make very thin veins using the small hole pot as shown in this 4-inch bait.

image.jpg

image.jpg

image.jpg

image.jpg

image.jpg

image.jpg

image.jpg

image.jpg

post-45771-0-19617500-1437286468_thumb.jpg

Edited by Geegeebaits
Link to comment
Share on other sites

This bait was poured from a Lee pot. I have been pouring baits for years using these pots and yes they are tricky to say the least. You can purchase pots with small holes in the spouts and purchase pots with the regular hole size too. You can make very thin veins using the small hole pot as shown in this 4-inch bait.

 

Man, if I can pour something anywhere close to those, I'll be thrilled!

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...


×
×
  • Create New...
Top