wickedmega Posted August 20, 2015 Report Share Posted August 20, 2015 I have these 4 inch multiple jointed swim bait blanks(see pic). I custom paint them.That's the easy part.But when it's time to apply my 2 part epoxy(even with a very small brush)the clear gets in between the joints rendering the bait useless even before it's dry! I was looking for any techniques i could use to make the clearing part(the most important part)be 100 % successful.I need my lures to be "flawless"! Any help on this would be of Great Appreciation!!!!! Thank You! : ) Quote Link to comment Share on other sites More sharing options...
gone2long Posted August 20, 2015 Report Share Posted August 20, 2015 Think you'll find it better to post in the hard bait forum me thinks this section is site related Quote Link to comment Share on other sites More sharing options...
wickedmega Posted August 20, 2015 Author Report Share Posted August 20, 2015 Think you'll find it better to post in the hard bait forum me thinks this section is site related Yes,i did that already after i realized that i posted my question here by mistake. Thank You though. : ) Quote Link to comment Share on other sites More sharing options...
