FLIPPY Posted March 26, 2016 Report Share Posted March 26, 2016 Hey guys..I was wondering what is safe to clean oil residue from molds and injector Quote Link to comment Share on other sites More sharing options...
rynesgto Posted March 26, 2016 Report Share Posted March 26, 2016 I use acetone an a tooth brush, iv never had any issues. Cleans it real well Quote Link to comment Share on other sites More sharing options...
curt k Posted March 26, 2016 Report Share Posted March 26, 2016 (edited) I use dish soap to wash my production molds before shelving or shipping them . Palmolive or sunlight are very safe to use on aluminum . I give them a scrub then lean them up to drip dry , then pat them on a towel to get the remainder of the water out I learned the hard way that dish detergent for washing machines is very bad for them though . the molds turned purplish and were rough feeling , I ended up turfing the whole lot http://www.enforcerbaitmolds.com/ Edited March 26, 2016 by curt k Quote Link to comment Share on other sites More sharing options...
CNC Molds N Stuff Posted March 29, 2016 Report Share Posted March 29, 2016 Soap and water works just fine. I've been using dawn for a few years now. Quote Link to comment Share on other sites More sharing options...
