chas48 Posted August 20, 2016 Report Share Posted August 20, 2016 Want to make them in 1/16oz...........All I can find is the 1/16 oz ball jig. I would like a tapered head. Quote Link to comment Share on other sites More sharing options...
Basseducer Posted August 20, 2016 Report Share Posted August 20, 2016 Here is a 1/32 & 1/16 oz. http://store.do-itmolds.com/Bullet-Jigbr132-116brHk-570-or-575brCollar-Barb_p_409.html Quote Link to comment Share on other sites More sharing options...
chas48 Posted August 21, 2016 Author Report Share Posted August 21, 2016 Thx.....want it weedless Quote Link to comment Share on other sites More sharing options...
Long Lake Lures Posted August 21, 2016 Report Share Posted August 21, 2016 Have a look at the walleye jighead. But you will need to modify it to accept a weedguard- not too tough if you can use a wire Quote Link to comment Share on other sites More sharing options...
Walking Dead Posted August 21, 2016 Report Share Posted August 21, 2016 http://www.barlowstackle.com/Do-It-Poison-Tail-Weedless-Jig-Molds-P264C56.aspx Use this 1/8 ounce. Cut that back barb collar off or figure out how to fill the cavity some to reduce the weight. Quote Link to comment Share on other sites More sharing options...
chas48 Posted August 24, 2016 Author Report Share Posted August 24, 2016 ^^ this is closer ...anybody know what to fill the cavity with to get it down to 1/16th ? Quote Link to comment Share on other sites More sharing options...
Walking Dead Posted August 24, 2016 Report Share Posted August 24, 2016 http://www.hiltsmolds.com/PerfectReplicaMold.htm Research this. Quote Link to comment Share on other sites More sharing options...
Jig Man Posted August 25, 2016 Report Share Posted August 25, 2016 ^^ this is closer ...anybody know what to fill the cavity with to get it down to 1/16th ? I use JB weld. I fill the cavity then start drilling and pouring until I get what I want. If I go too deep, I put JB back in the cavity and start drilling again. I have one mold that has poured several thousand heads and the JB is still holding on. Quote Link to comment Share on other sites More sharing options...
gone2long Posted August 25, 2016 Report Share Posted August 25, 2016 I use JB weld. I fill the cavity then start drilling and pouring until I get what I want. If I go too deep, I put JB back in the cavity and start drilling again. I have one mold that has poured several thousand heads and the JB is still holding on. X2 jb weld is very machineable. Quote Link to comment Share on other sites More sharing options...
