ravenlures Posted August 27, 2016 Report Share Posted August 27, 2016 Has anyone ever tried FLEX SEAL rubber as a mold for pouring lures. I use the silicone but just wondering about this Flex Seal. Wayne Quote Link to comment Share on other sites More sharing options...
ravenlures Posted August 29, 2016 Author Report Share Posted August 29, 2016 Well I guess its up to me, will let you know when I get some. Quote Link to comment Share on other sites More sharing options...
Travis Posted August 29, 2016 Report Share Posted August 29, 2016 I don't recall anyone using it yet. There was post within 3 weeks I believe where someone was asking the same but I don't recall any "yeah it works" replies. Quote Link to comment Share on other sites More sharing options...
JRammit Posted August 30, 2016 Report Share Posted August 30, 2016 The previous thread was posted in soft plastics (can't seem to find it now).... Heat and warping were the issues with flex seal..... Way less heat with resin than hot plastisol, but I would worry about the stuff holding its shape..... Also wonder about strength in any thin areas.... Might be good for a few baits, but I doubt you'll get a long term mold out of it It's not that expensive tho, so worth a shot.... Let us know Quote Link to comment Share on other sites More sharing options...
ravenlures Posted August 30, 2016 Author Report Share Posted August 30, 2016 I will just get a small amount to test I just pour resin, what the heck and any left over I can fix that dam gutter. Wayne 1 Quote Link to comment Share on other sites More sharing options...
CNC Molds N Stuff Posted August 30, 2016 Report Share Posted August 30, 2016 If you want a long lasting mold for resin go with something tough like Sorta-Clear. I've used it for food molds (it's food grade) with good success and it's quite strong when cured. Quote Link to comment Share on other sites More sharing options...
Chuck Young Posted August 30, 2016 Report Share Posted August 30, 2016 Or you can always make an airboat! Yahooooo! 1 Quote Link to comment Share on other sites More sharing options...
CNC Molds N Stuff Posted August 31, 2016 Report Share Posted August 31, 2016 (edited) Or you can always make an airboat! Yahooooo! I could I suppose, but airboats restrict the casting options for the back seater. Edited August 31, 2016 by Bob La Londe 1 Quote Link to comment Share on other sites More sharing options...
