Jump to content

Recommended Posts

I assume the problem was the reason you greased /oiled what ever that 5500c.

 You said, "it stops at a certain point...."   same place all the time ?

 if yes, you might try the following.   If I had that reel I`d fix it other wise my comments are a guess.

 Remove the pawl from line guide assembly.   What that does is remove the pawl from making contact with the worm shaft.   Some time there is a skin watcher under the pawl cap. watch for that.   Some time!

Make a cast and see if that thing still stops at a certain place.  If the problem

 still exists , I`d say there is an internal problem. Go to U-Tube for a tutorial

 on tear down.

If the problem has been corrected,  I`d say either your pawl or worm gear is bad .

  In some cases ...both.   

 Accessing a problem after some one has worked on the reel  is never good. 

   Meaning if you were good at reel work you would have fixed this thing.

   Hope my "possible" corrective action helps get your reel problem corrected

  

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...


×
×
  • Create New...
Top