Jump to content
probass

proper setting for LEE Pot 1-10

Recommended Posts

Something to keep in mind with a Lee pot...  The heating element only knows two speeds, 0 or 100%.  The "thermostat" just shuts the current to the element off when it (the air temp inside the "stand) hits a certain temp.  I install a small lamp in the power lead from the stat to the element so I can easily see when there is power going to the element (heating).   I also make a wire holder that suspends a kitchen thermometer in the plastic, just above the bottom of the crucible.  After a while you will get the knack of when (what temp) to turn the knob down (cut off power to the element) so the temp will not go past your target temp.  When I was getting it all dialed in, I saw huge swings after I stopped power to the element ie. cutting the power at 325 degrees and watching the plastic temp run up to 380 degrees, even with the pot unplugged.    

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...


×
×
  • Create New...
Top