Jump to content
Nevois90

Ice rod winding check

Recommended Posts

I’m building a custom jigging rod with a SKSS real seat and my blank butt is 5mm the smallest winding check I can find is 7mm ID what’s the best way to build up the blank to fit, any help will be appreciated... thank you 

Share this post


Link to post
Share on other sites

Not sure if you figured this out or not. I'm new to this forum. I build a lot of ice rods in the fall\winter. I just use wrapping thread under where the oversized winding check butts up to the handle. Keep adding layers until you have a snug fit. Then apply finishing epoxy. I usually coat over the winding check with the epoxy to give it a smooth transition to the blank.

Capture.PNG

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...
Top