Jump to content
Jazzatomo

Silicone Moulds From Soft Baits

Recommended Posts

G'day all, 
Asking a question for a mate back here in Australia who is a bit(Massively) technology inept.

He has been attempting to make silicone moulds of some soft jerkshads from one of our Australian makers over here. The problem he is running into is that the silicones wont set, or will get distortions and marks along what should be a smooth surface.

I have recommended sealing them with nail polish or silicone, but was wanting to reach out and see if anybody has worked out a best solution for the issue. 

TIA and best regards. 

Jake

Link to comment
Share on other sites

In past I had similar troubles trying to copy, with a 2 parts room temperature silicone, some chinese soft baits, instead I did not find any kind of troubles copying right "good" plastisol softbaits, so I think that such kind of marks depend by the raw material of soft baits that you will like to copy (especially the surface painted ones).

Bye Cami

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...


×
×
  • Create New...
Top