Coley Posted December 28, 2004 Report Share Posted December 28, 2004 Here is an idea I have tried, and it works. On foam baits if you would like to have a hollow section inside, put a piece of styrofoam on your through wire, after you pour your bait and the foam is well cured, drill a hole from the top or bottom of your bait and pour some Acetone into the hole it will dissolve the styrofoam and leave a hollow area inside your bait. You may seal the hole with a piece of balsa or wooden dowel. You could use this as a rattle chamber, or whatever you can think of. Maybe you could leave it open and put some alka-seltzer in for bubbles. Or possibily put another small hole into it from the front and force water out the top. Who knows, ues your imagination. Coley Quote Link to comment Share on other sites More sharing options...
MaddoxBay Posted December 28, 2004 Report Share Posted December 28, 2004 Coley you are pushing the envelope everyday. That is a great idea with endless possibilities. Quote Link to comment Share on other sites More sharing options...
Hilton Posted December 28, 2004 Report Share Posted December 28, 2004 Working with foam is just great....... Keep the imagination pushing and you will get great results..... I?m doing something simillar...... First I started gluing a plastic straw filled with bbs onto the wire...... Now I?m actualy putting the straw inside de mold with one of it?s end facing the mold wall. This leaves me an open chamber so I can put bbs, add and position ballast or even leave it hollow to get more boyanci. For tests, just close the open end with tape.... Quote Link to comment Share on other sites More sharing options...
