madbass Posted May 1, 2005 Report Share Posted May 1, 2005 I have about 2/3 of a gallon soft hand pour that I let sit still on my table for about 2 weeks. It is in a transparent jug that I transfered it into. It did not "seperate" at all, like other gallons that I have had. Has anyone else experienced this? I've also had alot more problems with tiny bubbles in this batch. Quote Link to comment Share on other sites More sharing options...
NJFishRGuy Posted May 1, 2005 Report Share Posted May 1, 2005 Funny you mention that... I opened a new gallon container yesterday. (It had been sitting on a table, not on the cold concrete floor.) I mixed it for 4 minutes with a drill mixer and put some into a smaller container I use. It sat for about a half hour, then I mixed it gently by tilting the container back and forth; there were no visible bubbles. But when I melted the plastic and went to pour, the first bait was completely covered with very small bubbles. They eventually cleared up but it took quite a while. There was a thread about something similar a while back; here's the link. Other than the bubbles, the baits I poured turned out fine. http://www.tackleunderground.com/board/viewtopic.php?t=4757&highlight=calhouns+bubbles Quote Link to comment Share on other sites More sharing options...
NJFishRGuy Posted May 1, 2005 Report Share Posted May 1, 2005 I also found this thread, which is more recent... http://www.tackleunderground.com/board/viewtopic.php?t=5439 Quote Link to comment Share on other sites More sharing options...
log Posted May 2, 2005 Report Share Posted May 2, 2005 Lately i've been getting tons of small bubbles when i pour. They don't appear until the plastic gets close to pouring temp. They do eventually go away, but it takes quite a bit of reheating first. Quote Link to comment Share on other sites More sharing options...