Sign in to follow this  

need info..

3 posts in this topic

You can check out some of the tutorials on this board and get a good idea of how it's done. You don't need much; wood, Devcon 2 Ton epoxy, stainless steel wire (I use .029" 180lb test leader wire), a 12"x12" sheet of polycarbonate (e.g. Lexan) for the lip (if needed), lead or silver solder and a soldering iron to put in the ballast, and whichever colors of aerosol latex paint you like (and use a flat white to basecoat before coloring). I use a disk sander to taper baits and a Dremel sanding drum to round off edges. You will probably want other tools and supplies to fine tune subsequent baits but this short list will do to start.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this