Jump to content
23 replies to this topic
Posted 28 February 2006 - 08:49 PM
Great read and thanks for the info on the other forum.
I tried the photobucket site and so I'll try it again.
Posted 01 March 2006 - 06:36 AM
Nice job. BTW, I experimented with Plasticoating a test piece which was glued together. It adheres perfectly and I think the thinner helps weld the joint.
They say that using pvc primer and Pvc glue is the prefered method of joining it. Nasty stuff which should be done in a well ventilated area, preferably oouside.
Posted 01 March 2006 - 06:18 PM
I've found that if I just use a fine sandpaper and make sure I scuff up all of the surface when I epoxy the two sides together that I have no problems. I found that I don't have to put on a thin layer first. It holds just fine. I ran off a batch of ten baits and glued them up just last night.
I want to finish the one in the pic which by the way is not yellow as the picture shows but is a nice white color.