Sign in to follow this  
Followers 0
finlander

Etexing w/o dive lip installed

5 posts in this topic

I want to clearcote a foil lure but I want to make the lips interchangable. I have made a larger rack hooked up to the new rotissiere motor. Any suggestions would be appreciated. I want to spin these w/o the kip installed. That was to be the way I wanted to mount the lures to this new rack...clapping them by the lip to the rack. Hope this helps. :?

Share this post


Link to post
Share on other sites

you could put a dummy lip in, or use a screw to hold your bait. we put lips in afterward the clear.

Share this post


Link to post
Share on other sites

But the idea is not to have one bond in place. I want to be abble to switch out bills of diff sizes/materials. :?

Share this post


Link to post
Share on other sites

just a thought try wax paper over the dummy lip. i pull the dummies when the clears soft it works.

Share this post


Link to post
Share on other sites

why not attach by the back of the lure and then cut the lip slot after the epoxy sets? if you cut the slots for the lips about 24 hours after curing before the epoxy gets fully cured you will get cleaner slot, as it cures further it becomes tougher to get good slot cut as epoxy becomes harder (brittle)

b9_1_sbl.JPG

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0