Jump to content
coley lexon crank lips
2 replies to this topic
Posted 27 March 2006 - 11:25 AM
coley kbkindle here copeyed your info on making your own bills
understand about all except where you put eye after you bend wire and into hole in bill do you glue it to bill also i assume after wire is bent and goes under bill to back of bill the wire is exposed and then glue with bill to bait. kb thanks
Posted 27 March 2006 - 10:14 PM
Look at the pictures close. The wire is not glued to the lip.
At the rear end of the lip I cut a notch, the wire folds up over
this notch. Then the lip is epoxied into the bait. This is the only
place any glue is applied to the wire.
DONOT GLUE THE WIRE TO THE LIP ANYWHERE, IT WON'T
HOLD. And it will only make a mess of your lip.
Posted 28 March 2006 - 06:53 PM
kb thank again some times ia'm a little dumb but i just want to get it correct thanks kb