tlyonshunter

looking for a tube tail cutter

8 posts in this topic

get a peace of wood (2x4) or whatever you have around. get 10 razer blades (stanley) comes to mind (box cuter).and slivers of wood (popsicel sticks). stack the 11 sticks and 10 blades together. cut a peace of wood 1/8" smaller than the stack. put the stack on top of that. cut 2 peices of wood that hight. use 4 bolts to hold all of it together. you need to drill 2 holes threw the 3 blocks of wood and 2 to cradle the blades. it will look like a razer sanding block. oil the blades set the tube on it and cut using another block of wood. good luck i hope you under stand what im trying to say no pictures.

Share this post


Link to post
Share on other sites

that is the same thing i am talking about. but that one is $30.00 plus shiping. theres is presher fitted as well. the only diff. is the one you make your self is free if you already have the blades. as you can see theres have the blades in it as well.

Share this post


Link to post
Share on other sites

ok get some onesided blades (razor) that is used by painters to scrape off paint on windows #superglue #JB WELD #clamp # now line up your blades clamp them a little super to hold them then after the glue is dry JB WELD ON THE BACK AND SIDE8O

Share this post


Link to post
Share on other sites

If you send me your Email address I will send plans of the rotary cutter I use.It works very well.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now