Jump to content
10 replies to this topic
Posted 15 May 2007 - 04:42 PM
Finally got the dies done and the punch peress running! The ones on the left are Poly with the paper still on them. The others are G10. The bigger one is the same side as the bill on an RC3 by Poes. Watcha think???
Posted 21 May 2007 - 10:23 AM
Sorry I had to go to MA for a week. I will try posting it again.
Posted 24 May 2007 - 08:02 AM
try to post a pic of the actual die if you can. That sounds interesting and would be a huge help.
Posted 07 July 2007 - 03:33 PM
Well my trip to MA was a disater! I fell and broke a few ribs and hurt my back. So finally here they are. I will post a pic of the dies later.
Posted 07 July 2007 - 10:24 PM
They look good! Sorry about your fall, musta been a doozy. Try not to read any funny posts; it's bound to hurt when you laugh. Good luck with your healing!
Posted 08 July 2007 - 02:57 AM
goodlooking lips u got there Mavrick, hope you heal up fast
Posted 08 July 2007 - 07:21 PM
Drinking on the rocks can seriously damage your health!
Posted 09 July 2007 - 07:16 AM
Those would be perfect for me. Post the die when you can, alot of members here would be able to benefit from that especially if it is a design that can be modified for other conditions. Sorry about your fall, we hope you heal soon, you're missing the fishing season.
Posted 09 July 2007 - 02:15 PM
I would like to see the die also. Did you make the die yourself? If so, what kind of steel did you use? Tool Steel?
Hope you heal up quick. I will keep you in my prayers for a speedy recovery.