Jump to content
3 replies to this topic
Posted 16 September 2007 - 10:07 PM
I haven't made baits since last year and the leftover resin is thickening in the bottom of the bottle. There is about 25% left. I tipped the bottle the other day and left it, but some resin was still clinging to the bottles' bottom? Is it salvageable??? ( The hardener is fine.)
Posted 16 September 2007 - 11:38 PM
I'd pitch it. I let some I had get over a year old, and it began not curing as it should; and it wasn't even doing what your is doing. It sure isn't worth screwing up even one lure IMO! I believe some others have had similar problems with old epoxy.
Posted 17 September 2007 - 12:54 AM
if it's got cold it'll go thick,try heating the bottles in warm water to see if this thins it out again,then do a test mix to see how in reacts before you use it on your lures
Posted 17 September 2007 - 11:04 AM
Hot water did the trick, it's flowing good now. Thanks!!