Lurehead03
-
Posts
239 -
Joined
-
Last visited
Lurehead03's Achievements
-
That Ukranian mold company mold material (Baitmold.com)
Lurehead03 replied to aulrich's topic in Soft Plastics
It's called Corian -
Corian Nat brave enough to try aluminum yet I've cut Aluminum but it's wasn't pretty it' a just a chineese cnc router with a geko 540 and upgraded steppers
-
always drill line up pin holes last went with .002 on ribs .004 on others but i'm going to surface .001 off as last pass made the gate bigger so in about 12hr.s we'll see if it works
-
This is what I've come up with whats the verdict
-
Thanks for comments I've used .003 but seems to let to much flash in Think i'll take one bait away so I can vent each rib and make sprue bigger and try that
-
What is a good depth for vents in a CNC mold so that there is not much flash? Sugestions on venting this
-
$" crawfish I designed caught alot of fish on it -
I have 2 used Del's 5.25 stick molds For Sale $55+ $6shp USPS/priority or $100tyd for both They have been modified for injecting
-
sorry for your quag i was going to order some from them but think i will wait and see if you get satisfaction
-
what tater said !!!! go to hobby lobby with the 40% off cupon
-
here is one i made used a crappie float and sand paper
-
i use the 5min HL epoxy for bills and line ties,hook hanger etc. i use devcon 2t 30min (from hobby club) for top coat most of the time it will 75/25 devcon and etex makes it brush on smoother and releases bubbles better than devcon by it self just be sure to mix the sh@#t out of it
-
is this what you are looking for http://www.normanlures.com/products/view/6/52
-
here you go
-
that what i did now i have 2 harbour freight abs 1 master and 2 paasche vls in a drawer and never use
