i0nized

I uploaded a few pictures of my fluid bed setup that connects to a compressor (link below). I used 2" male and 2" female PVC adapters with the female adapter epoxied to a plexiglas base. To connect to my compressor, I bought a 1/4" ball valve and an 1/4" air line male connector at the local box store. I had to flip the valve handle so it would open/close the direction I wanted it to. I don't have a tap/die set so I drilled a hole slightly smaller than the fitting and then slowly screwed it in to thread it. I then backed it out and wrapped the threads with some teflon tape and replaced the ball value fitting. Snug as can be! The regulator is barely opened at all and doesn't even register on the compressor's gauge. It's more of a place your hand over the fluid bed and feel kind of thing. Fine adjustments come with the ball valve. Works like a champ. Fluid Bed Setup