Thanks. I think I will give this way that Mark posted a try. Sounds like it will work
One way to cut slots after the lure is already shaped is to put a temporary piece of stiff wire into the back and belly, drilled exactly into the centerline, and sticking out an inch. Cut two spacer blocks exactly half the thickness of your bait, and use them as guide blocks. Lay the wires of the bait on the two blocks, and your bait will be exactly square to the bandsaw table, and to the blade, too. It's harder to explain than it is to do, but it's much easier and better just not to forget to cut the slot while the bait is rectangular. Doh!!! Hahaha