|
Re: Metal Forming - Arbor Press?
It will depend on the material, size and thickness. I have several pnuematic punch presses that I use to punch out crankbait lips. These are made of thin 1/16 or less poly or G-10(circuit board) if you are punching 1/8 stainless steel for example this would not be sufficient. An arbor press will punch out one lip at a time if you have the dies and the material is thin. BUT! It sure will make yor arm tired! I'm sure a small die set and punches could be made for less than 700$ If your looking for something specific I could run your parts for you if you supply the dies. Good Luck!
MAV
|
