Quote:
Originally Posted by HellRAISER
how do you guys glue the foil on the crank....ro better say with what
|
I typically used a spray on adhesive (3M is the brand that I used). However, other brands work as well. A super strong adhesive isn't necessary. After spraying I let the spray foam up a little before covering and smoothing the lure in candy wrapper foil (I just use this because it is thinner). Be careful not to rip the foil! Do one side at a time then cut the foil on the top and bottom of the crank but leave overlap to the other half. Then spray the other side and put your foil on as you did before. Then using a fresh and sharp razor, slice down the middle of the bait (try to remove just the top foil layer w/out cutting through to the first foil application). Next, if there is wood exposed and you plan on not painting over with a solid color, cut a thin strip of aluminum and place it over the top and bottom seams (from the razor) of the bait. Let dry for alloted time and then roll your desired pattern on (I use the handle of a ratchet tool). I've had good results w/ this. Mix in transparent paints and you will be amazed at the outcomes! (Be sure to put a clear coat over your foil after you roll your design and before you begin to paint!)
Live2Fish~Fish2Live
