[jimbo]

The printing is on the long section about six inches from the butt and yes the short section slides over and down the blank.The tip measures 0.0135"and the butt is 0.900 on the short section.When the pieces are joined the decal is 2" above the joint. When joined there is no play or wobble in it .there,s 3" inside the base is this enough to use as an extension that i could epoxy and start wrapping.It would be my first build so if it,s already been butchered i can,t really do any more damage ,just a thought. If the blank was actually designed this way i would hold off and build it later when i,ve gained some experience and build it the way it was meant to be done. Hope this makes sense to someone out there i just read it and well i,m a little dizzy,lol

Thanks Jim














































Thanks Jim