Hi , folks
Since my "SuperBug" version has already dried sufficiently from its linseedoil treatment (obviously takes a little less time on such lower density kind of abachewood
) , I have just now glued in its lip and connected wire harness .
It took me five glue mixing processes in total to fill up everything properly .
On such curvy shapes it can't be done with much less mixtures (also some spots at the sides of the lip's base remained uncovered at first) , since the glue tends to flow away from its location for some minutes until it sets , so I had to change position of lure a few times and apply new glue into the center slot and sideward lip slot
.
After at least 24 hrs. curing time I would then remove excess glue the same way previously shown with the teakwood "Banana's" !
After this removal I'd finally be ready to give my entire actual batch of "Banana's" , my first swimbait and two of Tacklejunky's "RoboMouse" versions the first clearcoat for first bath tube testing
!
Greetz , Dieter
