First off I want to say Hi to everyone here. I just joined a couple weeks ago and have been soaking up info from here like a sponge. I want to say thanks to everyone who has helped me with info through PMs.
I needed a Lure spinner/Dryer so I made one similar to one I saw here.
I then decided I would need something to hold the Lure while I was sealing it and the when I was painting it.
This works great and it was so easy to make.
I cut a 2X4 to 24"
I drilled two 3/4" holes and installed two pieces of 3/4" dowel.
I then drilled a hole through the top of each dowel.
I inserted a screw bolt though a washer then through the hole.
I center drilled a small piece of dowel for each side and screwed that small piece of dowel onto the eye bolt.
I used a wingnut to keep tension on the bolt.
I inserted a cup hook in the dowel and used rubber bands to hold the lure between the two hooks.
I can now spin the lure with either hand and the rubber bands keep just enough tension on the lure to keep it spinning nicely.
I made my drying rack tall enough that I can work on the lure directly below it so moving it up to spin is a cinch.
This only cost me a couple dollars to make. It's not high tech but it's going to work just fine.
