Hi , Sonny
Thanks for your kind words . I can definately assure you , that the "Heiddy" is a "killer lure" .
I advise you , not to embed the weight straightaway after the design sketch into the lure , I always clearcoat my jerkbaits with ordinary clear lacquer , assemble all hardware and fix a piece of wire to the linetie(resembling the wire leader) and now first determine about the weight needed to achieve desired sink rate in a water bucket .
Then I'd fix that weight with plastic tape onto the indicated location at lureblank and check for accurate horizontal sink position . I move the weight , until satisfied .
Due to different woods , that may be used , that location at the body can vary , hence my advice .
Did not do this with my first ones , and I was dissappointed about them not sinking quite level !

Good success with anything , that you're up to , diemai

Diemai
Checked out your submissions to the gallery and I am quite impressed! I like the Heidy's (I know them as Roach's). I was planning on making some of these when the Ludela's are done. The painted stripes method you created with O-rings was ingenious...............

Regards
Sonny

Hi , Sonny
Divani has sent me sketch copies of the "LUDELA" jerkbaits some years ago , but so far I only built the No. 6(out of 1 to 7)in all it's three sizes , also employed that sketch for the outer shape of my "Jointed Variations" , shown in the hardbait gallery . Even made a tailweighted topwater lure of this shape .
The line was designed by another Belgian guy Named LUc DE LAnge , hence the name of those lures .
On one of those "LUDELA 6" I've hooked a giant perch , scratching 50cm(20") , some years ago , but it came off at boatside , I am still a little disturbed about it .

Good success with your "LUDELA's" , diemai