|
Re: Pouring 3-4 inch grub molds?????
I doubt it unless you can find a thick one at least 1/16 or thicker.
The syringes were talking about are plastic but heavy duty.
You need to be able to pull the slide out to clean it as well.
I lube the tube end with a few drops of scent then put the slide in make sure it is free then I suck up the plastic, inject it, then squeeze the rest of plastic out and pull the slide back apart set it to the side, pour a few other molds, take the grub molds apart, clean the tip of the injector and re-peat, most of the time you can just stick a screw driver in the opening of the syringe to clear the hole without getting all the plastic totally out of the syringe as long as there is not to much in it.
Just make sure you lube it every time.
AND DO NOT BURN YOURSELF.
The quickest you can do it the better as the plastic can melt it if it stays in to long, I have never melted one but my tip is getting bad so I need to get more, I probably have done 500 with the same one so far and have many more it will do.
Did I mention CAUTION?
I did tip the mold over when injecting this week and it squirted and luckily I was wearing a heavy shirt
|
