Actually Vodkaman, I got the other mold to pour with only a couple small chips. So, I decided I’d mix up a little PoP and try to fill the chips and then sand it to match the mold. Little did I know, as soon as the wet PoP touched the cold mold it would set instantly. I waited a few hours and then tried to take some of the PoP off with a dremel. Rookie mistake, I gouged the mold pretty bad so I trashed it. The wax idea worked well, but was more work than it was worth. Had it been a more elaborate design I would be much more upset. In this case it was just a basic paddle tail worm. Oh yeah, I also used double sided take instead of super glue on this one and it made separation much easier.