sims7

What do use to to hold the wire stable in each section I see you have small holes drilled?

Well after 7 months of trial and error i had just about gave up when i went back and tried the tail like you said with the a piece milk jug and finally after months success put it together through the paint on it when hmmmm why is the paint not curing. didn't realize i needed a base coat of something other than createx. so i went with and when i put the d2t on it it started smearing. Gah only if i would took my time. well time to draw another one out. Trail and error is what its about if it was easy everyone would be doing it. But thanks for the tail idea with bristle and jrhopkins for the idea of pvc.

Great post it would have taken me month to figure it out. I wish I knew about this site a long time ago!

Ok I'm down to putting the tail on. How do you form the tail with the bristle. And get it to stay in the last section?

Thanks well time me to get to the making part thanks again

What would be a good thickness for a 6" .

Ok I got ya I never thought about splitting them. Thanks Mark

So do you think the millwork PVC work? I got it from Lowe's. It is a inch thick. Do you user a stencil or free hand the drawing of the fish on the board? Every time I draw it its never right one side is bigger than the other.

I got mill works PVC ? Those are some mighty fine lures John if mine would looks as half as good I'll be doing great

Thanks ! You think a brisol tail will work?

I am making a PVC swim bait and need ideas for the tail anyone have any suggestion?