Hey every! I'm new here. Tried to pour baits a few years ago and it didn't go very well. Got a couple batches of senkos using the Do-it kit. Well I'm going to try again and was wondering what plastic I should use? I will be making creature baits (Pitboss knock off) and will only be doing one cavity at a time. I think the single cavity will make it easier on me and also cut down on the problems I had. The senko mold was a 5 cavity and I got a lot of air bubbles in the baits or the plastic would cool before the final cavities were filled. So out of single pour I might get 1-2 baits out of the 5 cavities. Thanks for the help.