Bigkahuna807

Has anyone considered plexiglass for the divider? Also it looks like the divided cup ive seen uses the red high heat caulking as glue, the kind used for grills and smokers. I believe Home Depot carries it....Not sure if the plastic will stick to any of this stuff..??

Thanks for the info...Currently I spray the POP with high heat enamel with fair results, seems to "wear off" after several pours.I like the idea of epoxy, so I will try a few different of the suggested methods and see which works the best. Thanks again.

Hello everyone, I just recently started pouring my own soft baits and have a little experience pouring hard baits. I ran into a problem pouring 2 piece molds with the resin warping significantly and the POP molds don't warp and really turn out nice. So I got to thinking (look out) why not coat the POP with a very thin coat of resin ? Great detail with added strength and no warping. So Ive searched fairly extensively and haven't found much except on a few art sites that referenced coating plaster with epoxy. So I come to the forum...have any of you guys tried or heard of this idea? Any info is GREATLY appreciated....Thanks