Search the Community
Showing results for tags 'electrostatic spray gun'.
Found 2 results
-
Hi Looking for some more information on electrostatic conveyor painting system for lead heads. specifically a gun/ paint box set up that only coats the top half of the jig and the recovery system. from what I gather there are systems out there that don’t require the jugs to be masked off. Any insight into this would be much appreciated
-
I'm coming up on a sort of a pain project . I have to Paint a lot of spoons . Now this is normally no problem . This time though I have strict quality issues . Lately I seem to be suffering from brain block . So I'm asking for help from the great thinking guru's here . Here is the problem . I need to do about 100 at a time both sides and keep them from moving while I spray . Then at the same time I need to keep the holes in the spoon clear of paint. Next I need the rack/holder to be heat resistant and one that powder will not load up on when cured . I will be using an electrostatic spray gun . Toss something at me guy's . Any thoughts suggestions ANYTHING might help me break this brain block I have .
