RedRum Posted March 1, 2022 Report Share Posted March 1, 2022 I’ve been using Spray on Lu 213 on my dipping rods. It’s high heat with Teflon but expensive. I’ve had decent results with cheap canola spray but it’s cheap canola spray. My biggest challenge either way is getting the perfect amount of lubricant so the tubes don’t slide off during dipping and also so there’s enough lube left to slide the tubes off when the time is right. Any kind of input on anything herein mentioned would be appreciated. Thanks Quote Link to comment Share on other sites More sharing options...
Jig Man Posted March 1, 2022 Report Share Posted March 1, 2022 When I dipped I used canola oil on wood dowels. 1 Quote Link to comment Share on other sites More sharing options...
Bass-Boys Posted March 1, 2022 Report Share Posted March 1, 2022 I use worm oil on metal rods. Soak a napkin and wipe it on the rods 1 1 Quote Link to comment Share on other sites More sharing options...
Driftwood Posted March 1, 2022 Report Share Posted March 1, 2022 A very light coat of silicon spray. 1 Quote Link to comment Share on other sites More sharing options...
Travis Posted March 1, 2022 Report Share Posted March 1, 2022 3 hours ago, Bass-Boys said: I use worm oil on metal rods. Soak a napkin and wipe it on the rods Same way I have always done it. 1 Quote Link to comment Share on other sites More sharing options...
Painter1 Posted March 2, 2022 Report Share Posted March 2, 2022 Ditto on worm oil. 1 Quote Link to comment Share on other sites More sharing options...
Fern Posted March 2, 2022 Report Share Posted March 2, 2022 worm oil rubbed on all the rods is my method. I add a bit of scent to the worm oil sometimes as well. 1 1 Quote Link to comment Share on other sites More sharing options...
Les Young Posted March 4, 2022 Report Share Posted March 4, 2022 (edited) harbor freight acid wash brush dipped in worm oil Edited March 4, 2022 by Les Young 1 1 Quote Link to comment Share on other sites More sharing options...
