Jump to content

Search the Community

Showing results for tags 'soft plastic baits'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • TU Club Forums
  • General Discussions
    • TU Site Info & Updates
    • The Docks
  • Public Tackle Making Forums
    • Hard Baits
    • Soft Plastics
    • Wire Baits
    • Fly tying
    • Rod & Reel building & repair
    • Boatbuilding
    • Homebrew Tools
    • Hybrid Tackle
  • The Bait Shop
    • Classified Ads
    • TU Advertiser Forum
  • Knowledge Base
    • Member Submitted Tutorials
  • TU Events and Contests
    • TU Events
    • TU Lure Swap
  • Web Tools
  • News Archive
    • General News

Product Groups

  • TU Premium Membership
  • Advertisements
  • TU Swag

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL










Zip/Postal code


Found 3 results

  1. Its been a while since Ive made any soft plastic baits, but Im about to move to a location where the bass are plentiful, so Im looking forward to getting back into the hobby. I still have alot of mold old molds, but Ive noticed alot of the websites are no longer around (Bear Baits and Del Mart just to name a few). But i remember you could buy a Presto Fry Daddy from your local walmart then go online to a certain website and get a doohickey (yes, thats a word) made to fit on the top of the fry daddy that will constantly stir you plastic at a low speed, in order for the plastic not to burn. Problem is, I cannot find it anywhere. Is it no longer available? is there something better in its place?
  2. Hey guys, I have been making jigs for a little while now and started getting that down and wanted to expand into making soft plastic baits. I started off with just getting bass tackles starter kit, I've watched a lot of videos on shooting plastics and read up a lot. I'm having a problem with when I shoot the bait and pull it after its set up a bit there are air pockets in the rib on the bait but only on the top. I got the 3.5 BT bomb and it's a side injection mold. I've tried pouring the plastic into the injector, sucking up the plastic, and the rate at which I inject. I always top off the spur but I always have the air bubbles in the same place. Can anyone lend me some advice as to what the issue might be? It would be a great help. Thank you guys very much!!
  3. Not perfect, but it's awesome. After making my master out of craft Popsicle sticks and clay, making a mold out of POP, I have finally made my bait. Thanks to this website to which I came across less than a week ago I have achieved success. Thanks to those on tis site for help, especially Mantase and the videos from his website. I was trying to use silicon caulk and mess to make my mold, but it was a terrible episode of Breaking Bad
  • Create New...