DanT
-
Posts
3 -
Joined
-
Last visited
DanT's Achievements
Newbie (1/14)
0
Reputation
-
After you make your loop put the swivel on then squeeze the loop with a pair of pliers over bending it until the end of the wire goes past the shaft to one side. Then with your pliers carefully bring it back and twist at the same time until the end of the wire lines up with the shaft. This will close the gap.
-
After you make your loop put the swivel on then squeeze the loop with a pair of pliers over bending it until the end of the wire goes past the shaft to one side. Then with your pliers carefully bring it back and twist at the same time until the end of the wire lines up with the shaft. This will close the gap.
-
Has anyone used Jann's powder paint. I noticed it is a lot cheaper then Stamina's, and Barlow's powder paints. I was wondering if it was the same quality?